Erbium YAG Laser in Sarnia, Ontario
If you have searched for laser resurfacing, you have probably seen two names: CO2 and Erbium YAG. Both smooth the skin, but they behave very differently, and the difference matters for your recovery.

At a glance
- Healing
- About 5 to 7 days
- Anaesthetic
- Numbing cream
- OHIP
- Private fee
No. It is a cosmetic treatment.
No referral needed.
The Erbium YAG laser is known for precision. It removes skin in extremely thin layers with little heat, so healing is usually faster and gentler than with deeper lasers.
This page explains how it works, what it can and cannot treat, and what recovery really looks like.
Assessment before treatment. Every skin lesion is assessed before any laser treatment. The assessment combines Dr. Bastien's clinical experience and dermatology training with dermoscopy, digital imaging and AI-assisted analysis where appropriate.
Used for
Acne scars, surgical scars, uneven texture and selected benign growths
Precise
Removes skin a few microns at a time
Physician-led
Every spot and area is assessed by Dr. Bastien before treatment
Quick answers
What is it?
An ablative laser at 2940 nm that removes thin layers of skin
Does it hurt?
Numbing cream is used. Most people feel heat and prickling.
Downtime?
About 5 to 7 days for resurfacing. A few days for a small spot.
How many sessions?
1 for most benign growths. 3 to 5 for scars.
Is it safe for darker skin?
Often yes, with adjusted settings and preparation
Is it covered by OHIP?
No. It is a cosmetic treatment.
What is an Erbium YAG laser?
Erbium YAG (often written Er:YAG) is a medical laser with a wavelength of 2940 nm. The name comes from the crystal inside it: yttrium aluminium garnet, with erbium added.
It is an ablative laser, which means it removes a very thin layer of skin rather than only heating beneath it. New, smoother skin then grows back in its place.
How does it work?
The 2940 nm wavelength is absorbed by water more strongly than almost any other skin laser. Skin cells are mostly water, so the energy is used up right at the surface.
- The top layer is vaporized in a controlled way, often a few microns per pass
- Very little heat spreads into nearby skin
- The skin heals from the edges and from tiny healthy areas left between treated spots
- New collagen forms over the following months
Full or fractional. Full resurfacing treats the whole surface. Fractional treatment makes tiny columns and leaves untouched skin between them, so healing is faster. Your plan may use one or both.
What can it treat?
Acne scars
How it helps: Softens scar edges and evens texture. Typical sessions: 3 to 5.
Surgical and other scars
How it helps: Blends raised or uneven scars into nearby skin. Typical sessions: 2 to 4.
Seborrheic keratoses
How it helps: Removes the raised growth layer by layer. Typical sessions: 1.
Skin tags and small benign bumps
How it helps: Removes them with precise control. Typical sessions: 1.
Sebaceous hyperplasia and syringomas
How it helps: Flattens small raised bumps. Typical sessions: 1 to 2.
Uneven texture and fine lines
How it helps: Smooths the surface. Typical sessions: 1 to 3.
The Erbium YAG laser does not treat redness or broken vessels well. For those, a yellow vascular laser such as QuadroStar Pro Yellow is usually used instead.
Moles are not lasered without a diagnosis. A mole is assessed first. A mole that needs removing is usually removed surgically so it can be tested in a lab.
Erbium YAG vs CO2 laser
Both are ablative lasers, but they balance precision and heat differently.
| Erbium YAG (2940 nm) | CO2 (10,600 nm) | |
|---|---|---|
| Water absorption | Very high, so energy stays at the surface | Lower, so heat spreads deeper |
| Heat around the treated area | Low | Higher |
| Typical downtime | About 5 to 7 days | Often 1 to 2 weeks or more |
| Risk of lasting colour change | Lower | Higher, especially in darker skin |
| Skin tightening | Mild | Stronger |
For many people, Erbium YAG offers a good balance of results and recovery. CO2 may tighten more, but with a longer and harder recovery.
What happens during treatment
- 1
Assessment
Dr. Bastien examines the area and confirms the laser is suitable for your skin
- 2
Preparation
Skin is cleansed. Numbing cream is applied for about 30 to 45 minutes.
- 3
Protection
You wear eye shields throughout
- 4
Treatment
A spot takes a few minutes. Resurfacing a full face takes about 20 to 30 minutes.
- 5
Aftercare
A healing ointment is applied and you go home with written instructions
Not sure this is the right treatment?
Every spot is assessed before anything is treated. If another option suits you better, Dr. Bastien will tell you.
Recovery day by day
Recovery depends on how deep and how wide the treatment is. This is a typical guide for facial resurfacing.
- 1
Day 1
Redness, mild swelling, a warm sunburn-like feeling
- 2
Days 2 to 3
Skin feels tight. Light oozing or pinpoint crusting may appear.
- 3
Days 3 to 5
Flaking and peeling as new skin comes through
- 4
Days 5 to 7
Most flaking is done. Skin looks pink. Makeup can usually be used.
- 5
Weeks 2 to 6
Pinkness fades gradually
- 6
Months 1 to 6
Collagen keeps building and results keep improving
A single spot removal usually heals in about 5 to 10 days, with a small pink mark that fades over weeks.
Aftercare tips
- Keep the area moist with the ointment you are given
- Do not pick or peel flaking skin
- Use broad-spectrum SPF 30 or higher every day once healed
- Avoid strong sun, hot tubs, saunas and heavy exercise for a few days
- Restart retinoids and acids only once your skin has fully healed
Is the Erbium YAG laser safe?
When used after a proper skin assessment, it is a well-established laser with a good safety record. Like any procedure, it has possible side effects.
| Common and temporary | Less common |
|---|---|
| Redness and swelling | Darker patches (post-inflammatory hyperpigmentation) |
| Flaking and crusting | Lighter patches |
| Tightness and mild itching | Cold sore flare-up |
| Infection or scarring (rare) |
Darker skin. Erbium YAG is often a good choice for darker skin because it produces less heat than CO2. Settings are kept conservative, and a lightening cream before treatment and strict sun protection after may be advised.
Who should wait or avoid treatment?
- Pregnant or breastfeeding
- Active acne, infection or cold sores in the area
- Isotretinoin (Accutane) in the past 6 to 12 months
- A fresh tan or sunburn
- A history of keloid scarring
Tell Dr. Bastien about all your medicines, including blood thinners, at your assessment.
How long do results last?
Removed growths usually do not come back in the same spot, although new ones can form elsewhere over time.
Improvements in scars and texture are long-lasting, because the skin has been rebuilt. Your skin still ages naturally, and sun protection helps keep results.
Results vary from person to person.
Cost of Erbium YAG laser in Sarnia
Erbium YAG treatment for cosmetic concerns is not covered by OHIP.
Related treatments
- Acne Scar TreatmentErbium laser resurfacing and other treatments that soften acne scars over a series of sessions.
- Surgical Scar TreatmentYellow laser, Erbium resurfacing, injections or revision to make a surgical scar flatter and less red.
- Seborrheic Keratosis RemovalRemoval of seborrheic keratoses, the waxy, stuck-on growths, by freezing, scraping, shave removal or laser.
- Skin Tag RemovalRemoval of skin tags by snipping, freezing, heat or laser. Several tags can come off in one visit.
Frequently asked questions
What is an Erbium YAG laser used for?
Mainly acne scars, surgical scars, uneven texture and benign growths such as seborrheic keratoses and skin tags.
Does the Erbium YAG laser hurt?
Numbing cream is used, so most people feel heat and prickling rather than pain. The skin feels sunburned for a day or two.
How much downtime is there?
About 5 to 7 days for facial resurfacing. A small spot removal usually needs only a few days of minor care.
Is Erbium YAG ablative or fractional?
It is an ablative laser. It can be used in full mode, which treats the whole surface, or fractional mode, which treats tiny columns for faster healing.
Does it tighten skin?
It gives mild tightening as new collagen forms. Deeper lasers such as CO2 tighten more, but with longer recovery.
Is it safe for dark skin?
Often yes. It produces less heat than CO2, which lowers the risk of colour change. Settings and preparation are adjusted for your skin type.
How many treatments will I need?
One session for most benign growths. Scars usually need 3 to 5 sessions, about 4 to 6 weeks apart.
Do I need a referral?
No. You can book an assessment directly at 1692 Murphy Rd, Sarnia, by calling 1-866-550-MOLE (6653).
Book a consultation
You don’t need a referral. Dr. Bastien examines the area first and tells you whether you need treatment.
1692 Murphy Rd, Sarnia
Monday to Friday, 8:30 am to 4:30 pm
Free parking on site